34OPERATION4-1-1. CLERK SIGN ONYou have to program the System option about Clerk and set up thesecret code of the Clerk before operating the Clerk function.The system option has three types.One is used without the Clerk function, another is the Stay down mode,and the other is the Pop up mode.You have to operate according to how the System option was programmed.Two ways of operation are be available- Stay down operation- Pop up operationStay down operation requires a manual sign off.This mode is typically used in Supermarkets where only one operator usesthe register in a time period.Pop up operation signs off the operator automatically after each receipt.Therefore you have to sign on the operator before operating this model.This mode is used in restaurants or similar types of stores where serversone after the other are using the register during the same period.NOTE !! Refer to 3-1. SYSTEM OPTION and 3-6. CLERK.4-1-1. CLERK SIGN ONIf the System option about Clerk is set up, operate as follows:Then the end of display is showed the comma.n1 n2 n3 n4 -└─────┘ └ Clerk No.Secret codeExample. The Secret code of Clerk 1 is 111.You operate Clerk 1 in Stay down mode.1 1 1 1 CLERK * 1 C O* 1 0 0 0 0 0 51 5 . 2 6 3 0