Samsung DW80J7550UG User Manual

Also see for DW80H994 Series: User manual User manual User manual Installation guide User manual

English - 11Lack of salt indicator (*applicable models only)- Turns on when the water softener runs out of salt. (or the dishwasher isin the standby or pause modes.)- Turns off while the dishwasher is operating.10 Delay StartDelay a cycle for up to 24 hours in one-hour increments. To increase the delaystart time, press or hold the Delay Start button. The hour displayed indicatesthe time at which the wash will be started.- After setting the delay time, press the Start button, and then close thedoor to start the cycle.- If you want to change the delay time once the dishwasher has started,press the Reset button and turn off the dishwasher. Then, turn on thedishwasher again and select a new cycle with a new delay setting.11 StartTo start a cycle, press the Start button before closing the door.*Reset : To cancel a currently running cycle and drain the dishwasher, pressand hold the Start button for three (3) seconds.Once the dishwasher is reset, select a cycle and option, and then press Startto restart the dishwasher.You can select options (Self Clean, Upper, Lower, Speed Booster, Sanitize, Dry+, Delay Start) beforestarting a cycle. If you change the cycle after selecting an option, the original cycle is reset.To prevent the touchpad from losing response sensitivity, follow these instructions:- Touch the center of each keypad using one fi nger. Do not push.- Clean the touch control’s surface regularly with a soft, damp cloth.- Be careful not to touch more than one touch key pad at a time, except as directed.When you pause a cycle by opening the door during operation, press the Start button before closingthe door to continue the cycle.O O X03 using your dishwasherDW80H994_DD68-00164A-03_EN_150408.indd 11DW80H994_DD68-00164A-03_EN_150408.indd 11 2015-04-08 7:44:192015-04-08 7:44:19