Samsung DVG54CG7550 Series User Manual

Also see for DVE54CG7150 Series: User manual User manual Product guide

EnglishInstallationEnglish28STEP 4 Connect the water hoseThe dryer must be connected to a cold water tap using the provided water hoses.1. Close the cold water tap. If you have a washer’s coldwater hose attached to the cold water tap, unscrewand remove the hose. Then, connect the female endof the Y-connector to the cold water tap.2. Connect the straight end of the water hose to theY-connector.3. Using pliers, tighten the coupling an additional two-thirds turn. Do not overtighten because the couplingmay be damaged.4. Connect the angled end of the water hose to thefilling valve at the bottom of the rear frame. Turn thecoupling manually until it is tight.5. Using pliers, tighten the coupling an additional two-thirds turn. Do not overtighten because the couplingmay be damaged.6. If you detached the cold water hose from yourwasher, attach the hose to the open end of theY-connector, tighten the coupling by hand until it istight, and then, using a pliers, tighten an additionaltwo-thirds turn.7. Open the cold water tap, and then check for anyleaks.If the Y-connector cannot be directly connected to the cold water tap, use the short hose. See the “Usingthe short hose as an extension” section on page 29.Untitled-1 28 2023-03-21 11:33:42