Samsung DVE54CG7550 Series User Manual

Also see for DVE54CG7150 Series: User manual User manual Product guide

EnglishInstallationEnglish26STEP 3 Connect the electrical wiring (for electric models)Before connecting the electrical wiring, make sure you have read the “Electrical requirements” section onpage 21.3-wire systemA B C L2 L1DEA. External ground connectorB. Neutral grounding wire (white)C. Center silver-colored terminal blockscrewD. Neutral wire (white or center wire)E. 3/4” (1.9 cm) UL-listed strain relief1. Loosen or remove the screws from the centerterminal block.2. Connect the neutral wire (white or center wire) of thepower cable to the center, silver-colored terminalscrew of the terminal block. Tighten the screws.3. Connect the other wires to outer terminal blockscrews. Tighten the screws.4. Tighten the strain relief screws.5. Insert the terminal block cover into the rear panel ofthe dryer. Then, secure the cover with a hold-downscrew.CAUTION• To convert from the 4-wire system to 3-wire system,connect the ground strap to the terminal blocksupport to ground the dryer frame to the neutralconductor.• Ring-type terminals are recommended. If using strapterminals, make sure they are tightened.• Connect the power cord and check L1/L2/N voltage.If the voltage is low, it may not heat properly. Reviewthe “Electrical requirements” section on page 21 ifneeded.Untitled-24 26 2023-06-28() 2:56:15