Samsung DVE50M7450P User Manual

Also see for DVE50M7450 SERIES: User manual User manual User manual User manual User manual

Installation requirementsInstallation requirementsEnglish16Gas requirementsWARNING• Use only natural or LP (liquid propane)gases.• The installation must be conformed withlocal codes, or in the absence of localcodes, with the national fuel gas code, ANSIZ223.1/NFPA 54, latest revision(for theUNITED STATES), or with the natural gas andpropane installation code, CSA B149.1(forCanada).• Gas dryers are equipped with a burnervent for use with natural gas. If you planto use your dryer with LP (liquid propane)gas, it must be converted for safe andproper performance by a qualified servicetechnician. (LNG models only)You must check the burner of your modeland use the proper LP Kit accordingly. Tocheck the detail information of the burner,open the door and check the rating labellocation on the door frame.- 20,000 BTU: LPKIT-4/XAA (DC98-04114A)- 22,000 BTU: LPKIT-3/XAA (DC99-00792A)• A 1/2” (1.27 cm) gas supply line isrecommended and must be reduced toconnect to the 3/8” (1 cm) gas line on yourdryer. The National Fuel Gas Code requiresthat an accessible, approved manual gasshut-off valve be installed within 6” of yourdryer.• Gas dryers installed in residential garagesmust be raised 18 inches (46 cm) above thefloor.• Additionally, a 1/8” (0.3 cm) N.P.T. (NationalPipe Thread) plugged tapping, accessiblefor test gauge connection, must be installedimmediately upstream of your dryer’s gassupply connection.• Your dryer must be disconnected from thegas supply pipe system during any pressuretesting of the system at pressures greaterthan 1/2 psi (3.5 kPa).• Do not reuse old flexible metal gas lines.Flexible gas lines must be designed andcertified by the standard for connectors forGas Appliances, ANSI Z21.24 • CSA 6.10.NOTE• Your dryer uses an automatic ignitionsystem to ignite the burner. There is noconstant burning pilot.• Any pipe joint compound used must beresistant to the action of any liquefiedpetroleum gas.• As a courtesy, most local gas utilities willinspect a gas appliance installation.Commonwealth of Massachusettsinstallation instructionsYour dryer must be installed by a licensedplumber or gas fitter. A “T” handle manual gasvalve must be installed in the gas supply line toyour dryer. If a flexible gas connector is usedto install your dryer, the connector can be nolonger than 3’ (36”).WARNING• Gas leaks may occur in your system,creating a dangerous situation.• Gas leaks may not be detected by smellalone.• Gas suppliers recommend you purchase andinstall a UL-approved gas detector.• Install and use in accordance with themanufacturer’s instructions.DC68-03170Z-11_IB_DV7450M_EN_R.indd 16DC68-03170Z-11_IB_DV7450M_EN_R.indd 16 2023-06-30 3:23:322023-06-30 3:23:32