EnglishInstallationEnglish20STEP 4 Check the installation• All packaging material is completely removed and properly disposed.• The dryer is level and standing firmly on the floor.• Make sure no accessory remains inside the drum.• Do not block the air inlet hole of the cooling grill at the front of the dryer.• Do not place inflammable objects near the dryer and keep the surroundings clean.• Do not remove the adjustable levelling legs of the dryer. They are necessary to keep the dryer level withthe ground.• After installation, we recommend that you wait at least 1 hour before using the dryer.STEP 5 Power onPlug the power cord into a wall socket protected by a fuse or circuit breaker. Then, tap to turn on thedryer.NOTERun the Time Dry cycle for 20 minutes to make sure that it runs, heats, and shuts off. If the HC informationcode is displayed, contact a local service center.Door reversalYou might want to reverse the direction of the door, depending on your site conditions or to your needs.WARNINGMake sure door reversal is performed by a qualified technician.1. Open the door, and then remove the two screws onthe door hinge. While holding the door with bothhands, slightly lift to remove it.Untitled-2 20 8/11/2020 3:35:45 PM