Samsung DCS 50si User Manual

Also see for DCS 50si: User guide User guide

12PROGRAM STATION NAMESThis program is used to assign an 11 character name or identification for eachextension.PROGRAM KEYSUP & DOWN - Used to scroll and move cursor.KEYPAD - Used to enter characters.HOLD - Press to clear entry.Open customer programming and follow the instructions below.ACTION DISPLAY1. Press TRSF and then dial 104 [201] STN NAMEDisplay shows2. Dial station number (e.g., 205) [205] STN NAMEOR press UP or DOWN to select thestation and press the right soft key tomove the cursor3. Enter the station name using the [205] STN NAMEprocedure described on the next page SAM SMITHand press the right soft key to return tostep 24. Press TRSF to store and exitprogramming OR press SPK to storeand advance to the next programNOTE: Directory information is always 11 characters.DEFAULT DATA: NONENames are written using the keypad. Each press of a key will select a character.Pressing the dial pad key moves the cursor to the next position. For example, ifthe directory name is “SAM SMITH,” press the number “7” three times to get theletter “S.” Press the number “2” once to get the letter “A.” Continue selectingcharacters from the table below to complete your message. Press the “A” key tochange the letter from upper case to lower case.NOTE: When the character you want appears on the same dial pad key as doesthe previous character, press the UP key to move the cursor to the right.COUNT 1 2 3 4 5DIAL 0 Q Z . ) 0DIAL 1 space ? , ! 1DIAL 2 A B C @ 2DIAL 3 D E F # 3DIAL 4 G H I $ 4DIAL 5 J K L % 5DIAL 6 M N O ^ 6DIAL 7 P R S & 7DIAL 8 T U V ✱✱✱✱✱ 8DIAL 9 W X Y ( 9DIAL ✱✱✱✱✱ : = [ ] ✱✱✱✱✱The # key can be used for the following special characters: #, space, &, !, :, ?,., %, $, -, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \, “ and ~.13