Samsung DC68-03021F-06 User Manual

If the new dryer is installed into an existing exhaust system you must makesure:• The exhaust system meets all local, state, and national codes.• That a flexible plastic duct is not used.• To Inspect and clean all lint buildup from inside the existing duct.• The duct is not kinked or crushed.• The exhaust hood damper opens and closes freely.The static pressure in any exhaust system must not exceed 0.83 inches of water column, or beless than 0.This can be measured with the dryer running with a manometer at the point where the exhaustduct connects to the dryer. A no-heat setting should be used. The dryer tumbler should beempty and the lint filter clean.IMPORTANT TO INSTALLERPlease read the following instructions carefully before installing the dryer. These instructions should be keptfor future reference.A REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF A CHILD....... SUFFOCATING.LOCATION CONSI DERATIONSThe dryer should be located where there is enough space at the front for loading the dryer, and enoughspace behind for the exhaust system. This dryer is factory-ready for rear exhaust. To exhaust out thebottom or the right or the left, use the accessory exhaust kit. Instructions are included with the kit. It'simportant to make sure the room has enough fresh air. The dryer must be located where there is no air-flowobstruction.On gas dryers, adequate clearance as noted on the data plate must be maintained to ensure adequate airfor combustion and proper dryer operation.THE DRYER MUST NOT BE INSTALLED OR STORED IN AN AREA WHERE IT WILL BE EXPOSED TOWATER AND/OR WEATHER. THE DRYER AREA IS TO BE KEPT CLEAR OF COMBUSTIBLE MATERIALS,GASOLINE, AND OTHER FLAMMABLE VAPORS AND LIQUIDS. A DRYER PRODUCES COMBUSTIBLELINT. THE AREA AROUND THE DRYER SHOULD BE KEPT LINT-FREE.10 installing your ' dryer