Samsung DC68-02836B User Manual

Contents

20_ installing your dryer6. Review Gas Requirements section.Remove the pipe thread protective cap.Apply pipe joint compound or about 1 1/2 wraps of Teflon tape over all threaded connections.Pipe joint compound must be resistant to the action of any liquefied petroleum gas.Connect the gas supply to your dryer.An additional fitting is required to connect the 3/4” (1.9 cm) female thread end of a flexible connector tothe 3/8” (1 cm) male threaded end on the dryer.Securely tighten the gas line fitting over threads.Turn on the gas supply. Check all gas connections for leaks using a soap solution.If bubbles appear, tighten the connections and recheck.DO NOT use an open flame to check for gas leaks.3-WIRE system connections1. Loosen or remove the center terminal block screw.2. Connect the neutral wire (white or center wire) of the power cord to the center, silver-coloredterminal screw of the terminal block. Tighten screw.3. Connect the other wires to outer terminal block screws. Tighten screws.4. Tighten the strain relief screws.5. Insert the tab of the terminal block cover into your dryer’s rear panel slot.Secure the cover with a hold-down screw.1. External ground connector2. Neutral grounding wire (green/yellow)3. Center silver-colored terminal block screw4. Neutral wire (white or center wire)5. 3/4” (1.9 cm) UL-listed strain reliefIf converting from a 4-wire electrical system to a 3-wire, the ground strap must bereconnected to the terminal block support to ground the dryer frame to the neutralconductor.installing your dryerWarninGDV520AE-02836B_EN.indd 20 2010-06-03 �� 5:38:26