Samsung DC68-02347B-05 Owner's Manual

If new dryer is installed into an existing exhaust system you must make sure:• The exhaust system meets all local, state, and national codes.• That flexible plastic duct is not used.• Inspect and clean all lint buildup from inside the existing duct.• The duct is not kinked or crushed.• The exhaust hood damper opens and closes freely.The static pressure in any exhaust system must not exceed 0.83 inches of water column, or be less than 0.This can be measured with the dryer running with a manometer at the point where the exhaust ductconnects to the dryer. A no-heat setting should be used. The dryer tumbler should be empty and the lintfilter clean.IMPORTANT TO INSTALLERPlease read the following instructions carefully before installing the dryer. These instructions should bekept for future reference.REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF ACHILD SUFFOCATING.LOCATION CONSIDERATIONSThe dryer should be located where there is enough space in front for loading the dryer, and enoughspace behind for the exhaust system. This dryer is factory-ready for rear exhaust. To exhaust out thebottom or the left, use the accessory exhaust kit. Instructions are included with the kit. It’s importantto make sure the room has enough fresh air. The dryer must be located where there is no air-flowobstruction.THE DRYER MUST NOT BE INSTALLED OR STORED IN AN AREA WHERE IT WILL BE EXPOSED TO WATERAND/OR WEATHER. THE DRYER AREA IS TO BE KEPT CLEAR OF COMBUSTIBLE MATERIALS, GASOLINE,AND OTHER FLAMMABLE VAPORS AND LIQUIDS. A DRYER PRODUCES COMBUSTIBLE LINT. THE AREAAROUND THE DRYER SHOULD BE KEPT LINT-FREE.ALCOVE OR CLOSET INSTALLATIONWARNING – The dryer must be exhausted to the outside to reduce the risk of fire wheninstalled in an alcove or closet.• No other fuel-burning appliance should be installed in the same closet as the dryer.• WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED TO THE OUTDOORS.See EXHAUST INFORMATION section.• Minimum clearances between the dryer and adjacent walls or other surfaces are:2” in front, 17” on top, 1” on either side, and 2.375” in the back.• Closet front must have two unobstructed air openings for a combined minimum total area of72 in² with 3” minimum clearance on the top and bottom. A louvered door with equivalent spaceclearance is acceptable.Installation InstructionsSAMSUNG Dryer Owner’s Instructions A-3