Samsung CMD6638 Instruction Manual

Contents

4Wireless Receiver InstallationDetermine if you will be using the receiver cradle, or connecting the cables directly to the receiver beforeinstallation:1. Place the receiver cradle or receiver in a place that will have clear reception with your camera(s).2. Plug the AC adaptor power output cable into the 5V POWER input of the cradle or receiver. Plug thepower plug into a wall outlet or surge protector.3. Leave the receiver to charge for several hours prior to first time use so the built-in rechargeablereceiver battery is fully charged. DO NOT remove the power cable from the receiver / from the cradleduring initial charge process. After initial charge, charge the receiver as required.4. If you wish to view the receiver images on a larger screen, connect the included AV cable to the cradleor receiver, and connect the other end of the cable to the Video IN (Yellow) and Audio IN (White) ports onthe TV, VCR or other viewing/recording device.If you wish to view the receiver images on the computer, connect one end of the included USB cable tothe receiver, and connect the other end of the cable to the USB port on the computer. (Need to installdriver in the disc first).NOTE: the purpose of the AV output is for convenience only. When using with large screen TV/Monitor,the picture might be grainy as the camera limits video resolution to VGA (640x480 pixels). This is not aproduct defect. For best performance use with TV/Monitor PIP (Picture in Picture) function.Check your TV/Monitor product manual to see if this feature is available on your TV/Monitor. This allowsyou to view TV or other video source and see video from the camera in a small window on the samescreen.Wireless CameraFront & Back Controls1. Camera Antenna – Sends & receives signals to or from the receiver.2. Night Light Switch – Press to turn the night light ON orOFF. Alternatively, press the light button on the receiver toremotely turn the camera light ON or OFF.Note: Night Light is available only when the camera is pairedto the receiver.3. Lens/IR LED Cover – Infrared LEDs provide viewing inno/low light conditions4.Temperature Sensor--- Use to make a temperatureinduction in the camera side5. Microphone – Receives sounds for the area near thecamera, and transmits sound from the camera to thereceiver.6. Pair Button – The pair button is located on the back of the camera behind the stand mount.