Samsung CHT-420 Service Manual

Also see for CHT-420: Instruction manual Instruction manual Service manual Manual de instrucciones

Contents

IMPORTANT SERVICE GUIDE◆ MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT1) When installing the ass’y deck on the Main PCB, be sure to align the assembly point of mode switch.ASSEMBLY POINTVCR MAIN PCBFig. 1◆ HOW TO EJECT THE CASSETTE TAPE(If the tape is stuck in the unit)1) Turn the Gear Worm Œ clockwise in the direction of arrow with screwdriver. (See Fig. 2)(Other method ; Remove the screw of Motor Load Ass’y, Separate the Motor Load Ass’y)2) When Slider S, T are approach the unloading position, rotate holder Clutch counterclockwise after inserting screwdriver in theframe’s bottom hole in order to wind the unwound tape. (Refer to Fig. 3)(If you rotate Gear Worm Œ continuously when tape is in state of unwinding, you may cause tape contamination by grease andtape damage. Be sure to wind the unwound tape in the state of set horizontally.)3) Rotate Gear Worm Œ clockwise using screw driver again up to the state of eject mode and then pick out the tape. (Refer to Fig. 2)Fig. 2 Fig. 3Œ GEAR WORMFRAME