Samsung CBAP210A User Manual

IMPORTANT NOTE:This module is intended for OEM integrator. The OEM integrator is still responsible for theFCC compliance requirement of the end product, which integrates this module.20cm minimum distance has to be able to be maintained between the antenna and theusers for the host this module is integrated into. Under such configuration, the FCCradiation exposure limits set forth for an population/uncontrolled environment can besatisfied.Any changes or modifications not expressly approved by the manufacturer could void theuser's authority to operate this equipment.The OEM integrator is responsible for the compliance to all the rules that apply to theproduct in to which this certified RF module is integrated.This module must be integrated into a device where the user cannot access the antennaconnector and should not be able to remove or install the module.USERS MANUAL OF THE END PRODUCT:In the users manual of the end product, the end user has to be informed to keep at least20cm separation with the antenna while this end product is installed and operated. Theend user has to be informed that the FCC radio-frequency exposure guidelines for anuncontrolled environment can be satisfied. The end user has to also be informed that anychanges or modifications not expressly approved by the manufacturer could void theuser's authority to operate this equipment. If the size of the end product is smaller than8x10cm, then additional FCC part 15.19 statement is required to be available in the usersmanual: This device complies with Part 15 of FCC rules. Operation is subject to thefollowing two conditions: (1) this device may not cause harmful interference and (2) thisdevice must accept any interference received, including interference that may causeundesired operation.The final host product still requires Part 15 Subpart B compliance testing with the modulartransmitter installed.LABEL OF THE END PRODUCT:The final end product must be labeled in a visible area with the following " Contains TXFCC ID: A3LCBAP210A ". If the size of the end product is larger than 8x10cm, then thefollowing FCC part 15.19 statement has to also be available on the label: This devicecomplies with Part 15 of FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference and (2) this device must accept anyinterference received, including interference that may cause undesired operation.IC StatementThis Class B digital apparatus complies with Canadian ICES-003.Operation is subject to the following two conditions: (1) this device may not causeinterference, and (2) this device must accept any interference, including interference thatmay cause undesired operation of the device.Cet appareil numérique de la classe B est conforme á la norme NMB-003 du Canada.This device and its antenna(s) must not be co-located or operation in conjunction with anyother antenna or transmitter.The device could automatically discontinue transmission in case of absence of informationto transmit, or operational failure. Note that this is not intended to prohibit transmission ofcontrol or signaling information or the use of repetitive codes where required by thetechnology.

/ 6

Related manuals for Samsung CBAP210A