Samsung AE090JNYDEH User Manual

33English33EnglishADVANCED OPERATIONUse of wired remote controller installation / service modeUse of installation/service mode1 2 3 4Main menuSub-menu SEG Used1 If you want to use the installation/service mode for your wired remote controller, press the Setand ESC buttons at the same time for more than 3 seconds.• You will enter the installation/service settings, and the ‘main menu’ will be displayed.2 Refer to the list of installation / service setting mode for your wired remote controller on the nextpage, and select the desired menu.• Using the [ ]/[ ] buttons, select a main menu number and press the [ ] button to enter the sub-menu setting screen.• Using the [ ]/[ ] buttons, select a sub-menu number and press the [ ] button to enter datasetting screen.• When you enter the setting stage, the current setting value will be displayed.• Refer to the chart for data settings.• Using the [ ]/[ ] buttons, change the setting value. Press the [ ] button to move to the nextsetting value.• Press the Set button to save the setting value and exit to the sub-menu setting screen.• Press the ESC button to exit to normal mode.NOTE• When setting the data, you can move SEG range with [ ]/[ ] buttons.• While configuring the setting, press the ESC button to exit to the sub-menu setting screenwithout saving your changes.• When you don't enter any buttons for more than 3 minutes, you will be back to normal mode.