Menu
Samsung 932MW Quick Start Manual
                        |
Refer to Specifications > Preset Timing Modes for the resolutions or frequencies that aresupported by the monitor.3. Display Adapter DriverDisplay adapter refers to the computer video card driver.If the adapter is not properly set, you cannot adjust resolution, frequency or color and you cannotinstall the monitor driver.1. Checking Adapter DriverClick Start Settings Control Panel Display Settings AdvancedAdapter.If "Default" or a wrong product model is indicated, it means that the adapter driver is not properlyinstalled. Install the adapter driver again according to the information provided by the computer orvideo card manufacturers.2. Installing Adapter DriverThe instructions given below are for general circumstances.For specific issues, contact the relevant computer or video card manufacturers.1) Click Start Settings Control Panel Display Settings AdvancedAdapter Update Driver Next Display a list of the known drivers for this device sothat I can choose a specific driver Next Have Disk (Insert Video Card Driver diskette)OK Next Next Finish.2) In case you have Adapter Driver Setup file on your computer:Run Setup.exe or Install.exe, which is found in the Adapter Driver Setup file.4. Maintenance and Cleaning1. Maintaining the Monitor Case.Clean with a soft cloth after disconnecting the power cord.2. Maintaining the Flat Panel Display Screen.Clean with a soft cloth (cotton flannel) smoothly.z Do not use benzene, thinner or other flammable substances, or awet cloth.z We recommend a Samsung cleansing agent is used to preventdamage to the screen.z Never use acetone, benzene or thinner.(They may cause flaws or deformation of the screen surface.)z The user will be required to pay costs and related expenses forrepair of damages caused by him/her.5. Symptoms and Recommended ActionsA monitor recreates visual signals received from the computer. Therefore, if there is trouble withthe computer or the video card, this can cause the monitor to become blank, have poor coloring,noise, Video mode not supported, etc. In this case, first check the SOURCE of the problem, andthen contact a service center or your dealer.1. Check if the power cord and the video cables are properly connected to the computer.2. Check if the computer beeps more than 3 times when booting.(If it does, request an after-service for the main board of the computer.)3. If you installed a new video card or if you assembled the PC, check if you installed the adapter(video)driver and the monitor driver.4. Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz.(Do not exceed 60 Hz when using the maximum resolution.)5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, removethe Display Adapter at the "Control Panel, System, Device Administrator" and then reboot thecomputer to reinstall the adapter (video) driver. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved