English - 10Connecting a VCRThese instructions assume that you have already connected your TV to an antenna or a cable TV system (according to theinstructions on pages 6~7). Skip step 1 if you have not yet connected to an antenna or a cable system.1. Unplug the cable or antennafrom the back of the TV.2. Connect the cable or antenna tothe ANT IN terminal on the backof the VCR.3. Connect an RF Cable betweenthe ANT OUT terminal on theVCR and the ANT IN terminalon the TV.4. Connect a Video Cablebetween the VIDEO OUT jackon the VCR and the AV IN 1[Y/VIDEO] jack on the TV.5. Connect Audio Cablesbetween the AUDIO OUTjacks on the VCR and the AVIN 1 [R-AUDIO-L] jacks on theTV.If you have a “mono”(non-stereo) VCR, use aY-connector (not supplied)to hook up to the right andleft audio input jacks of theTV. If your VCRis stereo,you mustm connect twocables.Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.Each VCR has a different back panel configuration.When connecting a VCR, match the color of the connection terminal to the cable.When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does notmatch the color of the video cable (Yellow).Video ConnectionANT INVCR Rear PanelVideo Cable (Not supplied)4Audio Cable (Not supplied)RF Cable (Not supplied)TV Rear Panel
