ENG70To listen in the auto sound calibration mode, briefly press ASC button.• The selection alternates between ASC ON and ASC OFF in the display.• If you select "ASC ON", you will hear sound in the auto sound calibration mode.If you select "ASC OFF", you will hear sound in the mode set in the audio setting of the setup screen.1 Plug the auto sound calibrationmicrophone into the auto soundcalibration input jack.2 Place the auto sound calibrationmicrophone at the listener's position.45Press ASC button.When the message "REMOVE MIC"appears in the display, unplug the autosound calibration microphone.A bell sounds and thesetup finishes.• To create the optimal 5.1 channel sound filed, the selections are in thefollowing sequence: L ➝ C ➝ R ➝ SR ➝ SL ➝ SW• The auto sound calibration setup takes about 2 minutes to complete.3 Adjust the volume control on the mainunit as follows:• If the distance between the listener and the speaker is over 16.5 feet:Set the main unit's volume to over 25.• If the distance between the listener and the speaker is 10 to 16.5 feet: Setthe main unit's volume to 25.• If the distance between the listener and the speaker is less than 10 feet:Set the main unit's volume to 15.To cancel the auto sound calibration setup, press ASC button.• The tone output stops, "CANCEL ASC" appears in the display followed by "REMOVE MIC", and the setup is cancelled.A tone is output. A result for each speaker is displayed.SETUP
