Samsung 2.0041112184519e16 Instruction Manual

SETUP3635To set up Speaker BalanceTo set up Speaker BalanceL C RLSLFES RSD I G I T A LL C RLSLFES RSD I G I T A LL C RLSLFES RSD I G I T A LL C RLSLFES RSD I G I T A LL C RLSLFES RSD I G I T A L1 Use the Left/Right ( / ) button to raise orlower the output level of the chosenspeaker(s).Example: 5.1CH Sound SetupOFF, range of – 6 ~ 0OFF, range of – 6 ~ 0range of – 6 ~ – 00 ~ +6range of – 6 ~ – 00 ~ +6range of – 6 ~ – 00 ~ +6Front Speakers: L level, R levelRear Speakers: L level, R levelCenter SpeakerRear SpeakersSubwoofer SpeakerSound EditPress the Sound Edit button. Each time thebutton is pressed, the selection switches asshown below.2The display changes depending on the current audio outputmode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).While in DSP or PRO LOGIC mode, TEST TONE mayoperate differently for VCDs or CDs.Speaker Setting Methods• The test signal will be sent to the Left Front Center RightFront Right Rear Left Rear Subwoofer in that order.Test TonePress the Test Tone button.To End the Speaker SetupTest Tone• Press the Test Tone button again.LLS RSCSUBWOOFERRCreating Realistic Sound FieldsYou can use the following surround modes to reproduce a realistic sound field.• Digital Multichannel Surround —Dolby Digital and DTS Digital Surround• Dolby Pro Logic IIDolby Digital and DTS Digital SurroundTo enjoy surround effectively, all the speakers need to be connected and activated.Dolby DigitalUsed to reproduce multichannel sound tracks of the software encoded with Dolby Digital ( ).Dolby Digital encoding method (discrete 5.1 channel digital audio format)records and digitally compresses the left frontchannel,right front channel,center channel,left rear channel,right rear channel,and Subwoofer channel signals (total 6 channels,butthe Sub channel is counted as channel 0.1).In addition,Dolby Digital enables stereo rear sounds,and sets the cutoff frequency of the rear treble at 20 kHz,compared to 7 kHzfor Dolby Pro Logic.These facts result in better sound quality than Dolby Pro Logic.When the system detects Dolby Digital signals,the DOLBY DIGITAL indicator lights up on the display.DTS Digital SurroundUsed to reproduce multichannel sound tracks of the software encoded with DTS Digital Surround ( ).DTS Digital Surround is another discrete 5.1 channel digital audio format available on CD,LD,and DVD software.Compared to Dolby Digital,audio compression rate is relatively low.This fact allows DTS Digital Surround format to add breadth and depth to the reproduced sounds.As a result,DTS DigitalSurround features natural,solid and clear sound.When the system detects DTS Digital Surround signals, the DTS indicator lights up on the display.Dolby Pro Logic II• Dolby Pro-Logic II is a new multi-channel playback format developed by Dolby Laboratories using feedback logicsteering technology and offering improvements over conventional Dolby Pro Logic circuits.• Dolby Pro Logic II can be used to decode not only sources recorded in Dolby Surround ( ) but alsoregular stereo sources into five channels (front left, front right, center, surround left and surround right) to achievesurround sound.• Whereas with conventional Dolby Pro Logic the surround channel playback frequency band was limited, Dolby ProLogic II offers a wider band range.In addition, the surround channels were monaural (the surround left and right channels were the same) with previousDolby Pro Logic, but with Dolby Pro Logic II they are stereo.* Sources recorded in Dolby SurroundThese are sources in which three or more channels of surround have been recorded as two channels of signalsusing Dolby Surround encoding technology.Dolby Surround is used for the sound tracks of movies recorded on DVDs, LDs and video cassettes to be played onstereo VCRs, as well as for the stereo broadcast signals of FM radio, TV, satellite broadcasts and cable TV.Decoding these signals with Dolby Pro Logic makes it possible to achieve multi-channel surround playback.The signals can also be played on ordinary stereo equipment, in which case they provide normal stereo sound.Manufactured under license from Dolby Laboratories. “Dolby,”“Pro Logic,” and the double-D symbol are trademarks of DolbyLaboratories. Confidential Unpublished Works. ©1992–1997Dolby Laboratories, Inc. All rights reserved.Manufactured under license from Digital Theater Systems, Inc.US Pat. No. 5,451,942 and other world-wide patents issuedand pending. “DTS” and “DTS Digital Surround” aretrademarks of Digital Theater Systems, Inc. ©1996 DigitalTheater Systems, Inc. All rights reserved.