Samsung 2.004111209005e16 Instruction Manual

2143Setting the Speaker Mode Setting the Test TonePress MENU button.Press Cursorbutton to move to‘Audio’ and thenpress ENTER button.In the SpeakerSetup, press theENTER button again.L: Front Speaker (L) C: Center Speaker SW: SubwooferR: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)Press Cursor , ,, buttons to moveto the desiredspeaker and thenpress ENTER button.• For C, LS, and RS, each time the buttonis pressed, the mode switchesalternately as follows: SMALL ➝ NONE.• For L and R, the mode is set to SMALL.• With (Dolby Pro Logic II), the delay time may be different for eachmode.• With AC-3 and DTS, the delay time is set between 00 and 15mSEC.• Depending on PRO LOGIC and STEREO, the speaker mode may vary.Press RETURN button to return to the previous level.Press MENU button to exit the setup screen.47 48NoteSETUPSMALL : Select this when using the speakers.NONE : Select this when no speakers are installed.21 Press MENU button.Press Cursorbutton to move to‘Audio’ and thenpress ENTER button. 3 Press Cursor buttonto move to ‘TESTTONE’ and then pressENTER button.• The test tone will be sent to L ➝ C ➝R ➝ RS ➝ LS ➝ SW in that order.If the button is pressed again at thistime, the test tone will stop.To end the test tone,press TEST TONE button.Press TEST TONE button.• Test tone will be produced as follows:When playing a DVD or CD, this will workonly in Stop mode.• Use this function to check that each speaker iscorrectly connected and that there is no problem.When manually testing using the TEST TONE buttonMulti-Channel Pro Logic ModeStart