Salamander Pumps CT Series Installation And Warranty Manual

Also see for CT Bathroom 60B: Installation and warranty guide

Contents

Salamander Pumps CT Series Installation And Warranty Manual Manual pdf 12 page image

10Step 2: Connecting the pumpUse only Salamander supplied AV couplers to connect the pump.All associated pipework MUST be thoroughly flushed before making final connectionsto the pump. Fill the pump with water before connecting to the discharge pipework.The in-line strainers must be fitted to the hot and cold inlet supplies to the pump.A Hose to pipeworkThe anti-vibration coupler nuts needonly be finger tight plus one quarter turn.Mechanical tools must not be used totighten plastic coupler nuts as this maycause damage which will invalidate thewarranty.B Hose to pumpDo not twist or bend anti-vibration hosesas this will invalidate the warranty.Ensure that there are suitable meansof isolation for maintenanceFilter washers MUST be fitted to the inlets of the pump to validate your warranty.Flat washers must be fitted to the outlets. Flat and filter washers are supplied withthe pump.Isolating valveshown in ‘On’positionIsolating valveshown in ‘Off’positionFlat washerFit to outletFilterwashersFlatwasherFilter washerFit to inletx140812_SP_p2_rr_x140812_SP_p2_rr 16/10/2014 13:00 Page 10