OneStart

Menu

SANDIA aerospace SAE5-35 Installation Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Contents
  1. Record of Revisions
  2. Table Of Contents
  3. Section 1 - General Description
  4. Gillham Grey Code Output
  5. Extended Mode
  6. Environmental Qualification Form
  7. Section 2 - Installation Considerations
  8. Section 3 - Installation Procedures
  9. Static Port Connection
  10. Figure 3-2 J4/J5 Connector Wiring
  11. Figure 3-4 J4 Pinout
  12. Calibration
  13. Calibration Procedures
  14. Placarding
SANDIA aerospace SAE5-35 Installation Manual Manual pdf 9 page image
3.1 GENERALThe SAE5-35 is supplied with a mounting tray and solder type mating connectors. It is importantthat proper solder techniques be observed in attaching wires to the mating connectors. Failure to doso could result in a failure in the connection and cause intermittent or non operation of the SAE5-35.Section 3 Installation Procedures3.2 EQUIPMENT REQUIRED3.2.1 SuppliedSAE5-35 System 705154-00Includes: SAE5-35 Encoder 305154-00SAE5-35 Installation Manual 305186-00SAE5-35 Installation Kit 305216-0015 Pin Mating Connector 30521515 Pin Connector Hood 3052089 Pin Mating Connector 3052149 Pin Connector Hood 305207Mounting Tray 305145Knurled Holdown Nut 3051893.2.2 Required but not suppliedNumber 6-32 mounting screwsStatic port fitting3.2.3 Optional EquipmentAIM Annunciator, Installer supplied or Sandia Part Number 307217-003.3 MOUNTING TRAY INSTALLATIONThe mounting tray is mounted to the airframe using either three or four number 6-32 screws. Themounting hole pattern for the SAE5-35 mounting tray contains five holes. For new installations, it isrecommended that the four corner holes be used to mount the SAE5-35 tray. The fifth hole has beenadded to facilitate upgrades from other manufactures encoders. Refer to the SAE5-35 tray dimen-sions in Figure 3-1 to determine if the hole pattern of the removed system match the hole pattern ofthe SAE5-35 mounting tray.8 305186-00
/ 20
This manual is suitable for:
SAE5-35
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved