Reloop RP8000 Operation Manual

Also see for RP8000: Instruction manual Quick start guide

Contents

Reloop RP8000 Operation Manual Manual pdf 10 page image

VirtualDJ 8 – Reloop RP8000 10Slicer modePress the SLICER mode button to set the PADs to Slicermode.The 8 pads represent 8 sequential beats—"Slices"—in the BeatGrid. The playing Slice is represented by the currently lit pad.The light will "move through the pads" as it progresses througheach 8-Slice phrase. Press a pad to repeat that Slice (hold itdown if you want to keep looping it).Once the Pad is released the track will continue to play fromthe position it would have been if the pad was never pressed.While in Slicer mode, press the SLICER mode button again toset the PADs to Slicer Hold mode.(Led will blink)In this mode the pads offer the same functionality as in theSlicer mode, but in this case, the Slice is memorized on firstpress as the track continues to play. (HOLD mode).The unlit Pad will indicate the currently playing Slice.Hold the SLICER mode button down and then use Pads 1 and2 to increase/decrease the length of the applied loop on theslice.Hold the SLICER mode button down and then use Pads 7 and8 to increase/decrease the step (size) of the slice.Cue-Loop Dual modePress both the CUE and LOOP mode buttons to set the PADsto HotCue-Loop dual mode (both leds will turn on)In this mode the 4 upper Pads trigger HotCues 1 to 4 and the4 lower Pads trigger Loops (1/8 beats to 1 beat in size) ormomentary Loop Rolls (from 1/32 to ¼ beats).Hold* the CUE button down and then use the 4 upper Pads todelete their assigned HotCues.To trigger a Loop Roll, press the LOOP mode button (led willblink) and then use the lower Pads.While a Loop is triggered, hold the LOOP mode button downand then use the TRAX encoder (9) to move the loop forwardor backwards by half the size of the triggered loop*If no Pad is pressed while the mode buttons are pressed, the CUEor SAMPLER single mode will be selected once the mode button isreleased.

/ 13

Related manuals for Reloop RP8000