Reliable 6200VB Assembly

Reliable 6200VB Assembly Manual pdf 1 page image

CHIMNEYCORD SUPPORTPEDAL(S)CHIMNEYCORD SUPPORTPEDAL(S)VACUUM TABLE ASSEMBLY 6000VB/6200VBThese assembly instructions are based upon the 6200VB vacuumtable. Each vacuum table model varies slightly in design, but thegeneral assembly is the same for all.GENERAL1. Remove all packaging&wrap from the vacuum table.2. Confirm that you have the following loose parts:CHIMNEYCORD SUPPORTPEDAL(S) ÆThe 6000VB has two pedals.CHIMNEY1. From the side of the vacuum table remove the 2 BOLTS (use 8mmwrench) and the 4 SCREWS (use Phillips head screw driver).2. Using the 2 bolts and the 4 screws, attach the chimney (two peoplemay be needed for this task – one to hold the chimney and the other toattach it with the supplied hardware).CORD SUPPORT1. Remove the bolt and 2 washers from the top of the vacuum table (asmall hole will now be visible).2. Put 1 washer over the hole at the top of the vacuum table, place thecord support Êbase loopË over the washer then layer the secondwasher on top of the Êbase loop.ËUsing the bolt by placing it through the washers and Êbase loop,Ësecurely fasten the cord support to the vacuum table.PEDAL(S)1. Insert the small tabs on the foot pedal&plate into the smallcorresponding slots on the base of the table.BUCK POWER(6200VB)1. Open the ÊoutletË by lifting the Êlocking flapË firmly but carefully.2. Insert the 4-pin plug attached to the buck.*. Firmly close the Êlocking flap.ËBUCK POWERlocking flapscrewboltwasher4-pin plug

/ 2

Related manuals for Reliable 6000VB