Regency Fireplace Products Liberty LRI4E-NG Owners & Installation Manual

Contents

Regency Fireplace Products Liberty LRI4E-NG Owners & Installation Manual Manual pdf 24 page image

24 | LRI4E / HRI4E Direct Vent Gas Insert|24 installationHRI4E OPTIONAL LOG SET INSTALLATIONEnsure unit is cooled to room temperature and remove glass door.1. HRI4E Unit only.Remove burner (see manual for instructions).Remove existing pilot shield by removing 2 screws.Install pilot shield provided with Log Set using 2 screws fromprevious pilot shield. Reinstall burner.Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*For Touch Ups: Dark Brown paint is included.Note: This Log installation is for NG units only.1 Rear Centre Log2 Centre Right Front Angled Log Piece3 Right Forked Upright Log4 Left Angled Upright Log5 Left Angled Cross Log6 Right Front Angled Log Piece7 Centre Left Front Angled Log PieceRear Log Bracket (HRI6E/HRI4E units)Pilot shield (HRI4E units only)Lava Rock and Embers1234 765Glass/Beads quantities with Log installationHRI4E 6 lbsHRI6E 9 lbsNote: If glass previously installed - remove 2lbs to equal above quantity.2. Both HRI4E & HRI6E Units.Sweep glass aside from pilot covers (if already installed) to installRear Log Bracket, clip the front edge of the rear bracket on to rear ofthe burner as shown below.IMPORTANT: After the Rear Log Brackets are installed glass crystalsmust be reapplied. Glass crystals should not be higher then the rear logbracket but must cover the screen portion of the pilot cover. Pilot areaneeds to be clear to allow proper ignition.Rear Log BracketsNew Pilot Shield - HRI4E OnlyReapply glass crystals to pilot coverscreen. See picture on Step 3 Pilot AreaRear Log Brackets Pilot AreaNOTE: HRI4E shown above. The HRI6 pilot (not shown) is located onthe left hand side.OPTIONAL LOG SET INSTALLATION