Version 1.6.46NOVEMBER 17, 2011 ©2011 RED.COM INC.155REMOVING (UNDOCKING)1. Depress the two (2) release buttons located on the sides of the REDmote.2. Slide the REDmote upward to release from the V-Mount of the camera/module.3. Remove the REDmote.4. If the REDmote is on when undocked, “Reconnecting” will be displayed and the Green LED willflash. The REDmote will connect with the camera wirelessly (if the REDmote has been paired withthe camera previously).WIRELESS CONNECTIONPAIR CAMERA WITH REDMOTEWhen the REDmote is wirelessly connected to the camera, the camera ID will be stored in the REDmoteuntil the REDmote firmware is upgraded. After setting up the wireless connection, the REDmote willautomatically locate and connect to the camera whenever both are powered on.A camera can only be paired with one REDmote at a time (when you pair with a REDmote, the oldpairing is lost).To communicate to a desired camera wirelessly using the REDmote, perform the following procedure:1. Ensure the REDmote and camera are both are powered up.2. Ensure REDmote is NOT physically connected to the camera.
