Menu
Razor POCKET ROCKET Installation Manual
Also see for POCKET ROCKET: Owner's manualBattery installation instructionsOwner's manual
  |
Remove the plastic seat. The controller is located un-der the seat section (see Figure 1b).Using the supplied 5mm Allen wrench, remove thetwo screws that hold the plastic seat to the frame(see Figure 1a).Figure 1a Figure 1bFigure 2 Figure 3Carefully unplug the 5 wiring connections attachedto the controller. Each connector is a snap-lock typeconnection that requires depressing a small tab toallow the connector to release (see Figure 2). Donot attempt to disconnect by pulling on the wires!Using the 5mm Allen wrench, remove and save thetwo mounting screws that secure the old controller.You should now be able to remove the old controller(see Figure 3). Discard the old controller.Step 1a: Remove the motor coverStep 2: Unplug the wire connections Step 3: Remove the old controllerNeed Help? Visit our website for additional video instructions at www.razor.com or call toll-free at 866-467-2967 Monday - Friday8:00am - 5:00pm Pacifi c Time.CAUTION: To prevent shock, turn power switch off before installing the new controller.This kit includes:NOTE: The supplied adapter (6-pin connector on oneend and 4-pin & 2-pin connectors on the other end) isonly applicable to certain Pocket Rocket products.If your existing controller has a 6-pin connector, thereplacement controller will require use of the adapter.• The 6-pin connector of the adapter shouldbe connected to the Pocket Rocket.• The 4-pin & 2-pin connectors of the adaptershould be connected to the new controller.If your existing controller already has a 4-pin and a2-pin connection, disregard connecting the suppliedadapter.Step 1b:A B DE FGA - Washers (2)B - Lock Washers (2)C - 5mm Allen wrenchD - Pocket Rocket™ HandlebarReplacement bolts (2)POCKET ROCKET™CONTROLLER INSTALLATION GUIDE1E - AdapterF - Qili™ ChargerG - Controller(CT-201C6)C |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved