Menu
Rayrun T111 Manual
    |
Single Color LED DimmerIntroduction1. Power supply inputThe controller supply voltage range is from DC 5V to 24V.Please refer to the print on the controller for cable polarity.The output voltage is at the same level as the power voltage,please make sure the power supply voltage is correct and thepower wattage is capable for the load wattage. Please benoted the positive power cable is directly connected to theoutput cable inside the controller.Model: T111(-H)132Wireless RemoteOverheat ProtectionWide Voltage RangeMemory FunctionUltra CompactT111 LED dimmer is designed to drive constant voltagesingle color LED products such as LED strip or LED module involtage range of DC5-24V. The receiver works with the RFwireless remote controller, user can setup LED brightnessfrom the remote controller.Receiver & wiring1 250mm15mm38mmConnect to LED loads. Please refer to the print on thecontroller for cable polarity and connect LED load with2. LED outputaccording polarity. Please make sure the LED rated voltage issame as the power supply and the maximum load current isbelow the controller rated current.CAUTION! The controller might be permanentlydamaged if output cables short circuit. Please ensure thecables are well insulated to each other.To 110/230AC power5-24V DC outputPower supplyT111 LEDController5-24V DCLED LoadsLED Controller 5-24V Driving3. Wiring diagramPlease connect the controller output to LED loads andpower supply to the controller power input. The outputvoltage of power supply must be same as the LED load'srated voltage. Check all cables to be well connected andinsulated before power on.RemoteControllerRemote controller function45764. Turn ON / OFFPress ‘I’ key to turn on controller or press ‘O’ key to turnoff. The controller will memorize the on/off status and willrestore to the previous status on the next power on. Pleaseuse remote controller to turn on the unit if it was switched tooff status before power cut.5. Brightness adjustPress ‘+’ and '-' key to adjust brightness sequentially.Hold press these '+' or '-' key will adjust the LED brightnesssmoothly.* H version picture80%100% 60%20%40% 10%Advanced RF Remote |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved