OneStart

Menu

Ravo 54G User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Contents
  1. safety instructions
  2. fcc information
  3. Table Of Contents
  4. Overview
  5. Introduction
  6. Wireless Network Scenarios
  7. Hardware Description & Installation
  8. Rear Panel and Connector
  9. Hardware Connection
  10. Setting Up Ethernet / WLAN Client
  11. For Windows 98/ME
  12. For Windows 2000/XP
  13. Additional Settings for Wireless Client
  14. Checking Connection with the Access Point
  15. Web Configuration
  16. To enable Your Settings
  17. Viewing System Status
  18. Wireless LAN (2.4G)
  19. Wireless LAN Security
  20. Administration
  21. Specification
Ravo 54G User Manual Manual pdf 25 page image
4. Web Configuration174.2 Viewing System StatusClicking System Overview in the menu bar will display theSystem Overview page that shows basic information about the54Mbps Wireless Access Point, including the system, LAN andWireless LAN interface information. You may click the Updatebutton to update the overall status.Figure 4-2 System Overview4.3 LAN ConfigurationThe LAN configuration page allows you to define the IP address ofthe LAN port.X GeneralMAC Address. Displays the MAC address of the LAN port.X Manual ConfigIP Address/Subnet Mask. Enter the IP address and subnet maskfor the Access Point LAN port. All local wired/wireless devicescommunicate with the device through this port. It is also the IPaddress of the Web-based Configuration Utility. By default, the IPaddress and subnet mask of the LAN port is 192.168.1.1 and255.255.255.0 respectively. Note that if you change the private IPaddress and apply the changes, the PC from which you configurethe router will lose the communication to the router. To reconnect,
/ 39
This manual is suitable for:
54G
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved