Rane SEQ 30S Operator's Manual

Contents

Rane SEQ 30S Operator's Manual Manual pdf 1 page image

Manual-1QUICK STARTThis manual is for both the SEQ 30s and the SEQ 30L. The only difference is the length of the sliders. The units are electricallyand functionally the same. This manual will refer to “SEQ 30” for either unit.If this is your first equalizer, please do yourself and your speakers a favor and read at least the first five pages. “An ounce of pre-vention...,” and all that.The SEQ 30 is a stereo equalizer, so adjusting any slider affects both channels simultaneously. Begin by setting all sliders to theircenter detent (0 dB), and the INPUT LEVEL to its center detent (0 dB). Try to make more cuts than boosts. After equalizing, usethe EQ switch to compare equalized and non-equalized signal. While EQ is switched to Active (BYPASS button out), adjust the IN-PUT LEVEL to the same level as when EQ is switched to BYPASS (in).You may use either the XLR or ¼" connectors for Inputs or Outputs. Connect only one INPUT type per channel. The XLR and¼" TRS inputs do not sum. You may, however, use both types of OUTPUTS simultaneously if desired.WEAR PARTS: This product contains no wear parts.OPERATORS MANUAL SEQ 30S & 30LSTEREO GRAPHIC EQUALIZERS12-126-60STEREOEQUALIZER0+12699633120+1269963312SEQ 30L40031.525 40 6350 10080 160125 250200 315 12.5k1k630500 800 1.6k1.25k 2k 3.15k2.5k 5k4k 8k6.3k 10k 20k16kINPUTPOWER+4 OLLEVEL BYPASSSTEREOEQUALIZER0+12•6•••6120+12•6•••61212-126-60SEQ 30S40031.525 40 6350 10080 160125 250200 315 12.5k1k630500 800 1.6k1.25k 2k 3.15k2.5k 5k4k 8k6.3k 10k 20k16kINPUTPOWER+4 OLLEVEL BYPASS

/ 4

Related manuals for Rane SEQ 30S