Rain Bird ESP-LXD Installation, Programming & Operation Manual

Also see for ESP-LXD: Troubleshooting guide Programming guide Installation & troubleshooting guide

Contents

Rain Bird ESP-LXD Installation, Programming & Operation Manual Manual pdf 74 page image

68 ESP-LXD ControllerDecoder Barcode ScanningThe optional Decoder Barcode Scanning feature allows youto automatically enter Field Decoder Addresses into the ESP-LXD controller.Decoder barcode scanning is an optional feature of the ProgrammingBackup Cartridge (PBC-LXD) that lets you set up Field Decoder addressesin the ESP-LXD controller by using a barcode scanning pen to read theremovable barcode labels attached to Rain Bird’s field decoders (seeProgramming Guide instructions for more details).bb NOTE: The optional barcode scanning pen must be purchasedseparately. Rain Bird recommends using a Unitech MS100-2barcode pen with 9 pin (female) serial connector. Go to www.ute.com for more details.Install Barcode Scanning PenFor this installation, you will need the following:Programming BackupCartridge (PBC-LXD)Barcode Scanning Pen(Unitech MS100-2recommended)PBC-LXD RJ45Connector Cable(Included with PBC-LXD)Barcode Scanning Pen Installation ComponentsA Open the controller outer cabinet door and inner front panel. SeeSection H, Access Controller Cabinet for more details.B Press down on the top-latch of the cartridge bay cover (or PBC ifalready connected) and remove it from the back of the controllerfront panel.12C Plug the PBC-LXD RJ45 Connector Cable into the connection jackon the back-side of the PBC-LXD.3