Menu
Radiant Lighting FAZE LED STRIP COB Installation Manual
  |
LED STRIP COBCAUTION - light fitting must be installed by a licensed electrician.• Please ensure to read instructions correctly for the installation of the fitting provided. Failure to do so will result in a void of warranty andcompromises the safety of luminaire.• Radiant Lighting are not liable for warranties when luminaire is damaged by incorrect installation. The installation of the luminaires must bein accordance with the national safety regulations.Please refer to Radiant Lighting’s General Terms & Conditions for more information concerning the installation and warranty of our products.CategoryPowerIP RatingCRIINSTALLATION1. Check the required lengths of strip, and round measurements down to the nearest cutting point; in this case: 50mm2. Cut the strip between connection points to pre-measured lengths. Do not cut strip in any other spot (inbetween LEDs) as it will damagethe circuit and render that section unusable. Each section of the strip is made up of a separate circuit and can work independently(each 25mm / 50mm / 100mm can be lit on it’s own when cut and wired.)3. Choosing Drivers: Decide how many drivers you will need to complete your installation. If pre-cut lengths of strip are beinginstalled in different locations, you will need several drivers. If feasible, multiple cuts of strip can be linked back to onedriver.STRIP LENGTH WATTAGE PER METER 10% TOTAL WATTAGEX + =20LED Strip lighting14W p/m90+PCB3 YearsCalculate driver size required by using this simple equation:50mmFor warranty information please visit radiantlighting.com.au/warrantyFor all other queries, please call us on 1300 438 6094.Heat ShrinkCut heat shrink to required size then slide over the LED strip. Solder cable to the soldering pads and then slide heat shrinkback over and heat. |
Related manuals for Radiant Lighting FAZE LED STRIP COB
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved