RAB WPLED20 Installation Instructions Manual

Contents

troubleshooting

RAB WPLED20 Installation Instructions Manual Manual pdf 1 page image

20W LED WALLPACK INSTALLATION INSTRUCTIONSIMPORTANTREAD CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Propergrounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLEINSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT.WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.Thank you for buyingRAB LED lighting.Comments? Call us at888-RAB-1000, or email:marketing@rabweb.comJUNCTION BOX MOUNT FORCONDUITFor use on applications where conduit wiring is needed.1. Loosen and remove (4) Lens Screws. Remove Door.2. Loosen and remove (2) Housing Screws. RemoveHousing from Back Box. Keep Housing Gasket intactfor re-assembly.3. Secure Back Box to the mounting surface usinghardware appropriate for that mounting surface.4. Wire the fixture using UL listed wire connectorsaccording to NEC and local codes. Apply sealant to allunused conduit entry points.5. Place Gasket between Back Box and Housing.Re-mount Housing to Back Box. Check HousingGasket seal all around the Back Box.6. Re-mount Door to Housing. Tighten (4) Lens Screws.Check door gasket (not shown) seal.7. Fixture is UL Listed for down and up lighting and maybe mounted in either position. Fixture may not meltheavy snow accumulation in an uplight position.CAUTION: For proper weatherproof function all gasketsmust be seated properly and all screws inserted andtightened firmly.LensScrewsJunction Box Surface MountBack BoxHousingGasketHousingDoorHousingScrewsSURFACE MOUNT FORRECESSED JUNCTION BOXFor use with recessed junction box and wiring.1. Mount Surface Plate to fixture with (4) Surface PlateScrews. There are two screws from the front and twoscrews from the back. Make sure Housing Gasketmakes complete seal all the way around.2. Use supplied crossbar. Mount Crossbar to recessedjunction box with (2) screws.3. Place Junction Box Gasket on back of the fixture.Gasket should create seal against mounting surface.4. Wire fixture to supply wires in recessed junction boxaccording to wiring section.5. Use 1/4 x 20 stainless steel Mounting Screw to attachfixture to Crossbar. Tighten Mounting Screw.6. Cover screw with Cap, provided.7. Fixture is UL Listed for down and up lighting and maybe mounted in either position. Fixture may not meltheavy snow accumulation in an uplight position.CAUTION: For proper weatherproof function all gasketsmust be seated properly and all screws inserted andtightened firmly.CrossbarJunctionBox GasketMountingScrew CapRecessedJunction Box(not provided)SurfacePlateHousingGasket(4) SurfacePlate Screws

/ 2

Related manuals for RAB WPLED20