Quoizel WWD9009IB Installation Manual

Quoizel WWD9009IB Installation Manual Manual pdf 1 page image

1of3Please go to for product cleaning tips. Go to the selection.marking pen, 1/16”drill bit, center punch, hammer, drill and wrench.(1) A21 Medium Base bulb 150W Maximum, bulb not included.Missing Parts? Contact your original place ofpurchase.www.quoizel.com Care + MaintenanceLight Source:Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,Estimated Assembly Time:Preparation:20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture.For Style WWD9009IBWarnings and CautionsTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.Package ContentsA Mounting Screwx 3FixtureBodyx 1E Nipplex 1GSTEP 1 Remove Styrofoam inside of the Cage-A. Remove the cage from the Fixture Body (G) by loosening lockscrews on the bottom.B. Remove Styrofoam inside of the cage.2018 QuoizelInc. ReleasedDate:2018-05-04visit us on-line at www.quoizel.comStyrofoam(Remove)CageFixture BodyLock ScrewFigure 1Installation Guide #IS-WWD9009IBB Fixture Loopx 1C Rubber Washerx 1D Flat Washerx 1F Hex Nutx 1STEP 2 Install the Fixture Loop-A. Screw the Nipple (E) onto theFixture Loop (B) and hand tightenuntil snug.B. Pass the Nipple (E) through theRubber Washer (C), the hood ofthe Fixture Body (G) and the FlatWasher (D) in turn. Secure themtogether by threading the Hex Nut(F) onto the Nipple (E). Handtighten until snug.BCDFEGSTEP 3 Install the Bulb and Cage-A. the theB. Place the cage back onto theFixture Body (G) and secure withpreviously removed lock screws.Hand tighten until snug.Insert bulb onto socket andscrew snugly into place.Bulb (notincluded)Figure 3Lock ScrewCageFixture BodyFigure 2

/ 3

Related manuals for Quoizel WWD9009IB