4 – InstallationInstalling Firmware4-18 59096-06 ASTo install firmware using the CLI when a File Transfer Protocol (FTP) server ispresent on the management workstation, use the Firmware Install command.Refer to the SANbox 5600 Series Fibre Channel Switch Command Line InterfaceGuide for information about the CLI commands.1. Enter the following commands to download the firmware from a remote hostto the switch, install the firmware, then reset the switch to activate thefirmware.SANbox #> admin startSANbox #> firmware installThe switch will be reset. This process will cause adisruption to I/O traffic.Continuing with this action will terminate all managementsessions,including any Telnet sessions. When the firmwareactivation is complete, you may log in to the switch again.Do you want to continue? [y/n]: yPress 'q' and the ENTER key to abort this command.2. Enter your choice for the file transfer protocol with which to download thefirmware image file. FTP requires an user account and a password; TFTPdoes not.FTP or TFTP : ftp3. Enter your account name on the remote host (FTP only) and the IP addressof the remote host. When prompted for the source file name, enter the pathfor the firmware image file.User Account : johndoeIP Address : 10.0.0.254Source Filename : 7.4.00.11_mpcAbout to install image. Do you want to continue? [y/n] y4. When prompted to install the new firmware, enter Yes to continue or No tocancel. Entering Yes will disrupt traffic. This is the last opportunity to cancel.About to install image. Do you want to continue? [y/n] yConnected to 10.20.20.200 (10.20.20.200).220 localhost.localdomain FTP server (Version wu-2.6.1-18)ready.5. Enter the password for your account name (FTP only).331 Password required for johndoe.Password:******230 User johndoe logged in.6. The firmware will now be downloaded from the remote host to the switch,installed, and activated.
