Qlogic SANbox 5600 Series Installation Manual

Also see for SANbox 5600 Series: Brochure Supplementary guide Supplementary guide Guidelines Supplementary guide

Contents

Qlogic SANbox 5600 Series Installation Manual Manual pdf 31 page image

2 – General DescriptionFibre Channel Ports59096-06 A 2-5APort LEDsEach port has its own Logged-In LED (L) and Activity LED (A) as shown inFigure 2-4.Figure 2-4 Port LEDsPort Logged-In LED (Green)The Logged-in LED indicates the logged-in or initialization status of the connecteddevices. After successful completion of the POST, the switch extinguishes allLogged-In LEDs. Following a successful port login, the switch illuminates thecorresponding logged-in LED. This shows that the port is properly connected andable to communicate with its attached devices. The Logged-In LED remainsilluminated as long as the port is initialized or logged in. If the port connection isbroken or an error occurs that disables the port, the Logged-In LED isextinguished. Refer to “Logged-In LED Indications” on page 5-7 for moreinformation about the Logged-In LED.Port Activity LED (Green)The Activity LED indicates that data is passing through the port. Each frame thatthe port transmits or receives illuminates this LED for 50 milliseconds. This makesit possible to observe the transmission of a single frame. Logged-InLED (Green)Activity LED(Green)Logged-InLED (Green)Activity LED(Green)SFP Ports XPAK Ports