|
Installation Help 2 – Hardware Installation2-8 FC0151103-00 E10. Power up all external FC devices, then power up the PC and observe themonitor. The BIOS is disabled by default. Consequently, the devicesattached to the QLA22xx board are not identified. For example:QLogic CorporationQLA22xx PCI Fibre Channel ROM BIOS Version X.XXCopyright (C) QLogic Corporation 2000 All rights reserved.www.qlogic.comPress for Fast!UTILBIOS for Adapter 0 is disabledROM BIOS not installedNOTE:❑ Sun SPARC systems do not display the BIOS banner.❑ Enable the BIOS only if the boot device is attached to the QLA22xxboard.❑ For further information about enabling the QLA22xx BIOS, seeappendix A.If the information displayed on your monitor is correct, congratulations! You havesuccessfully installed the QLA22xx board in your computer.See the appropriate QLogic software installation guide for detailed instructions onhow to install the software drivers.If the information displayed is not correct and you have checked the QLA22xxboard’s configuration, see section 3 for troubleshooting information.2.5Installation HelpIf your system has an integrated drive electronics (IDE) fixed disk device, it may beassigned device number 80, which is the boot device. If your system does not havean IDE disk device, the first bootable FC disk device configured (the one with thelowest ID) is assigned device number 80 and becomes the boot device. TheQLA22xx BIOS must be enabled if the boot device is connected to the QLA22xx.If you have a selectable boot BIOS, set the motherboard BIOS parameters to Noneor Not Installed. The ROM BIOS on the FC controller automatically configures theFC peripherals.
|
