2–Configuring NICNIC Partitioning (NPAR)2-66 SN0054671-00 B3. Use the Configure Function dialog box to set the minimum and maximumbandwidth percentages, New Minimum BW (%) and New Maximum BW(%) (Figure 2-44).Figure 2-44. Entering New Bandwidth Values4. If desired, select the Make settings permanent check box to retain the newsettings.5. Click OK to save your changes.NOTE:Enhanced transmission service (ETS) only specifies the division ofbandwidth between FCoE and non-FCoE traffic. It does not specify thebandwidth allocated to the NIC or iSCSI partitions. When the switchsets ETS values, the ETS bandwidth parameters take precedence.The FCoE partition is allocated the bandwidth specified for FCoE in theETS parameters. The non-FCoE bandwidth is divided between the NICand iSCSI partitions in the proportion specified by the NPARmanagement UI. In other words, when ETS is in effect, the NIC andiSCSI bandwidth values specified by the NPAR management UI are nolonger a percentage of the total bandwidth. Instead, they are apercentage of the non-FCoE bandwidth.NOTE:If you do not select this option, the bandwidth values will revert to thedefault settings after you reboot the host server.
