7–Configuring FCoE in a Windows EnvironmentBoot from SAN7-24 FE0254601-00 An. Enable both Selective Login and Selective LUN Logins (Figure 7-10).Enabling Selective Logins restricts the discovery of targets [WWPNs]to what is specified in the database as a boot device. EnablingSelective LUN Logins restricts the discovery of LUNs to what isspecified in the database as a boot device LUN number.Figure 7-10. Edit Boot Settings Menuo. Return to the Main Menu, and select Write under Operation.p. Select Quit from the driver configuration Main Menu to return to the EFIshell.q. At the EFI shell, enter the following command to reboot the server:reset4. Insert the Windows installation media in the optical drive on the server; thewindows installation process starts automatically.The adapter drivers must be installed on the server during the installation ofthe operating system. For information about installing drivers, refer to“Installing Software” on page 3-7.5. After the operating system installation is complete and the server reboots,type the appropriate key sequence to open the system BIOS/EFI BootManager.6. Set the SAN boot device (QLogic adapter for BIOS; fibre disk for UEFI) atthe top of the boot order.NOTE:For information about using the QLogic 8100 Series EFI utilitiesand driver configuration, refer to “Configuration Settings” onpage 9-4.Edit Boot Settings0. Previous Menu1. Enable Alternate Boot Device [n]2. Enable Selective Login [n] Y3. Enable Selective LUN Logins [n] Y4. OS Mode [Windows/Linux/Other]5. EFI Variable EFIFCSanLevel [1]6. Enable World Login [n]
