Qlogic 2400 Series User Manual

Also see for 3200 Series: User guide User guide User guide

Contents

Qlogic 2400 Series User Manual Manual pdf 92 page image

5–Fibre Channel Noninteractive Commands-kr (Run Read/Write Buffer Test)5-22 SN0054667-00 BIf the read/write buffer test fails, the system shows the following information: Loop/port ID (the loop ID of the adapter when operating in loop mode). Status: Success—The test passed. Error—A data miscompare or link status firmware error occurred. Failed—A link status error, SCSI write buffer error, or SCSI read buffererror occurred. Unknown—The target was not present. Unsupported—The device does not support this test. Data Miscompare—The possible values are: 0 (no data miscompares) Device not present Get link status failed Read buffer failed R/W buffer not supported Write buffer failed Link Failure—Number of link failures Loss of sync—Number of sync loss errors Loss of signal—Number of signal loss errors Invalid CRC—Number of invalid CRCsTable 5-7. Data Pattern (DP) Test PatternsHex Binary00 0000000055 010101015A 01011010A5 10100101AA 10101010FF 11111111