OneStart

Menu

Qihan PTZ User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Contents
  1. Table Of Contents
  2. Chapter One Product Overview
  3. Chapter Two Wiring and Setup of Dome System
  4. II. Setting of Dome Device communication
  5. Chapter Three Fast Operation Guide of Dome Device
  6. IV. Install camera
  7. Chapter Four -English Operation Menu of Dome Device
  8. II. Tree Menu List
  9. Language Options
  10. Control Options
  11. System Options
  12. Camera Options
  13. Function Programming
  14. User Admin
  15. Date/Time
  16. Chapter Five Short-cut Operations and Specification of Dome Device
  17. Charpter Six Main Technical Parameters
  18. Chapter Seven Trouble Shooting of Dome Device
Qihan PTZ User Manual Manual pdf 10 page image
6Operation Manual of Intelligent High Speed Dome CameraChapter Three Fast Operation Guide of Dome DeviceI. Wiring .!Attention: No operation when the dome device is power on.II. Setting protocol and baud rate.The figure shows: Protocol: PELCO-D The figure shows: Auto detection protocol.Baud rate: 2400 bps Baud rate: 2400bps(Please refer to detailed parameter in next chapter) (Please refer to detailed parameter in next chapter)III. Setting dome device address.The figure shows: Address of the dome device: No. 1(Please refer to detailed parameter in next chapter)This dip switch located on PCB in the dome deviceSet address fordomeProtocolsettingBaud ratesettingProtocol settingBaud ratesetting(Please do not turn the power on)(Turn the power off when setting, and restart the device after revision)Orange RS485A(+)Yellow RS485B(-)Controller ofthe DomeYellow-Green Interphase ColorYellow-Green Interphase ColorBNC Video OutputRedBlackExternal Connection for Alarm Input/OutputAC24V InputConnected toGroundPower Supply of DomeDisplay
/ 44
This manual is suitable for:
PTZ
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved