QSC DCM-1 User Manual

Also see for DCM-1: Specification sheet

Contents

QSC DCM-1 User Manual Manual pdf 21 page image

211- IEC-style AC power cord (included with the DCM)2- QSC DataPort cable for every amplifier (8, 11, or 15 cables depending upon model)3- Cinema Processor cable (DB25 male-male)4- RS-232 cable (DB9 male-female, used only during setup with the DCM Manager software)5- Surround EX Decoder cable6- Shielded audio cable for Hearing Impaired and Powered Subwoofer outputs (if used)INSTALLATION- Connections: General Information and AC MainsCONNECTIONSMaking the required connections to the DCM is simple. Just make sure that you have all of the correctcables. “Mass-termination” connectors are used wherever possible. This reduces installation time fromhours to minutes and makes any required connection changes fast, easy, and reliable.REQUIRED CABLES (typical system)AC MAINS CONNECTIONLocate the IEC-style AC power cordsupplied with your DCM. Identifythe “IEC” end (molded plastic block),line it up with the rear panel IECreceptacle, and insert it fully.Plug the AC plug end of the cableinto a functioning AC outlet of theproper voltage.The DCM is equipped with a detachable IEC-style ACpower cord. To reduce the risk of accidental disconnect,secure all power cords in the course of installation.Before plugging your DCM into the AC mains, verify proper operating voltage. The serial number stickerlocated on the rear of the DCM has the rated operating voltage information printed on it. Locate the sticker,note the rated voltage, and ensure the AC circuit you intend to use is properly rated.IEC-style Molded AC Power Connector-