Pioneer SC-LX801 Basic Manual

Also see for SC-LX701: Product reference guide Basic Manual Basic Manual

Contents

> Before start > Hookup > Setup > Playback > Part Names27OthersListening To the Radio1. Press TUNER (a) on the remote controller repeatedly toselect either "AM" or "FM" on the display.2. Press MODE (c) on the remote controller, so that the"TunMode: Auto" is displayed on the display.3. When you press the  /  cursor (b) buttons on theremote controller, automatic tuning starts, and searchingstops when a station is found. When tuned into a radiostation, the "TUNED" indicator on the display lights.You can preset up to 40 stations.1. Tune into the AM/FM radio station you want to register.2. Press +Fav (d) on the remote controller so that thepreset number on the display flashes.3. While the preset number is flashing (about 8 seconds),repeatedly press the  /  cursor (b) buttons on theremote controller to select a number between 1 and 40.4. Press +Fav (d) again on the remote controller to registerthe station. When registered, the preset number stopsflashing. To select a preset radio station, press the  / cursor (b) buttons on the remote controller.0 To delete a preset station, press the  /  cursor (b)buttons on the remote controller to select the presetnumber you want to delete, press +Fav (d) on theremote controller and then press CLEAR (e) while thepreset number is flashing. When deleted, the number onthe display goes off.Frequency step settingPress the button on the remote controller to select"System Setup" – "Miscellaneous" – "Tuner" – "AM/FMFrequency Step" or "AM Frequency Step" and select thefrequency step for your area. Note that when this setting ischanged, all radio presets are deleted.cdeabMulti-zonePlay1. Switch the remote controller to the mode for controllingZONE 2 or ZONE 3.To switch to the mode for controlling ZONE 2, whileholding down MODE (a) on the remote controller, pressZONE 2 (b) for 3 or more seconds until the remoteindicator blinks twice.To switch to the mode for controlling ZONE 3, whileholding down MODE (a) on the remote controller, pressZONE 3 (c) for 3 or more seconds until the remoteindicator blinks three times.2. Point the remote controller at the main unit and press Í(e)."Z2" or "Z3" lights on the main unit display.3. Press the input selector button (f) of the input to beplayed in the separate room. On the main unit, afterpressing ZONE CONTROL several times to displayeither "Z2" or "Z3" in the display, within 8 seconds turnthe INPUT SELECTOR dial to select the input to beplayed in the separate room.0 You can only select the same inputs for the mainroom and separate room with the "NET" or "BTAUDIO", or "USB" input selector. If you have "NET"selected in the main room and then select "USB" inthe separate room, the main room also switches to"USB". You cannot select different stations for themain room and separate room with the AM/FM radio.0 DSD and Dolby TrueHD audio signals are not outputto ZONE 2/ZONE 3 when selected with the "NET",To return the remote controller to main room controlmode: While holding down MODE (a) on the remotecontroller, press MAIN (d) for 3 seconds or more until theremote indicator flashes once.abdcefSN29402400_SC-LX801_701_BAS_En.book 27 ページ２０１６年６月１３日月曜日午前９時２２分