Pioneer RX-Z15 Operating Instructions Manual

Also see for PL-Z85: Operating instructions Operating instructions

OperatingInstructionsSTEREO DOUBLE CASSETTE DECK RECEIVERRAHZIS7 IRXAZ55RX-Z45STEREO TURNTABLEPie Z85SPEAKER SYSTEMer es) B.Thank you for buying this PIONEER product.Please read through these operating instructions so you will know howto operate your model properly. After you have finished reading theinstructions, put them away in a safe place for future reference.in some countries or regions, the shape of the power plug and poweroutlet may sometimes differ from that shown in the explanatorydrawings. However, the method of connecting and operating the unitis the same.IMPORTANT NOTICE[For U.S. and Canadian models]The serial number for this equipment is located on the rear panel. Pleasewrite this serial number on your enclosed warranty card and keep it ina secure area. This is for your security.WARNING: To PREVENT FIRE OR SHOCK HAZARD, DO NOTEXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.* The RX-Z35, RX-Z45, PL-Z85 and S-Z35D are not sold in the U.S.A.and Canada. iThe RX-Z15 and RX-Z35 are not sold in Europe.LINE VOLTAGE SELECTOR SWITCHOnly multi voltage models are provided with this switch. U.S.,Canadian, European, U.K., and Australian models are not providedwith this Switch.Mains voltages in Saudi Arabia are 127 V and 220 V only. Never usethis mode! with 110 V setting in Saudi Arabia.Before your model is shipped from the factory, this switch is set to thepower requirements of the destination; nevertheless, you should checkthat it is set properly before plugging the power cord into the AC outlet.VOLTAGE SELECTOR1. Disconnect the power cord.2. Use a medium-size screwdriver.3. Insert the screwdriver into thegroove on the voltage selector andadjust so that the voltage value ofyour area:FM/AM CHANNEL STEP SWITCHAdjustment is only necessary when there is a CHANNEL STEP.Switch atthe rear panel. ~The CHANNEL STEP switch is located on the rear panel of the digitalsynthesizer tuner. Before the tuner leaves the factory, this switchis set to the channel step standard of the area where the tuner issold. Depending on the position of this switch, each time TUNINGbutton is pressed, the frequency display changes by the followingamount:[100 kHz/10 kHz] positionFor areas with channel step of 100 kHz for FM and 10 kHz for AM.150 kHz/9 kHz] position Sree De heeFor areas with channel step of 50 kHz for FM and 9 kHz for AM.NOTE:#f the switch is set to the wrong position, correct tuning may notbe possible.Consult your dealer if you are not sure about the radio channelstep standard in your area.@ PIONEER’The Art of Entertainment