Pioneer PT Series Operation & Maintenance Manual

Contents

PARTS ORDERWhen ordering parts from Pioneer Pump, Inc. please provide the following information:1) Pump serial number2) Pump model3) Cross section drawing number4) Part number from cross section drawing (or part name if no number is noted)5) Description of part6) Quantity required7) Package VIN (Vehicle Identification Number for skid or trailer mounted units)SPARE PARTSSpare parts should be kept on hand to reduce downtime. At a minimum the following partsshould be stocked.Wear PlateAll O-ringsSet of bearingsMechanical sealSet of grease sealsIf you have unusual pumping conditions, consult Pioneer Pump, Inc. for additionalrecommended spare parts.STORAGEPumps are adequately prepared for outside storage prior to shipment, but use the following listof additional suggestions for extended storage.1) Store the unit off the ground so no water will accumulate around the equipment.2) Protect unit from blowing sand and dirt.3) Stack no other items on top of pump/equipment.4) Protect unit from the entry of any animals.5) Periodically rotate shaft to lubricate bearings and protect bearings from brinelling.6) Protect unit with approved drying agents.7) Ensure all bare metal areas are coated with rust preventative.8) Inspect unit every four (4) weeks and replace drying agents (Silica Gel) as required or aminimum of ever six (6) months.9) Keep an inspection record showing dates of inspection with any maintenance preformedand condition of drying agents.10) Before installation ensure that all rust protection has been removed. Also, remove anyforeign material that may have accumulated during storage.11) Before installation remove all drying agents (Silica Gel).19

/ 22

Related manuals for Pioneer PT Series