EnglishInstallation4EnOPTION1RETURNSEL. OK: RGB: RGB: AUTO: 1080B: OFF: OFF1024 768EXITOSDBNC INPUTD-SUB INPUTRGB SELECTHD SELECTINPUT SKIPALL RESETMENUBottom sideTop sideCaution on when the plasma monitor is installed vertically• Use the optional unit. Contact your store of purchase when installing.• Rotate 90° clockwise as seen from the front when installing.• After installing, check with the PIONEER logo markas seen from the front.• Be sure to set “OSD ANGLE” to “V” when using.* Failure to heed the above cautions may lead to malfunction.How to use the remote controlBattery Installation and ReplacementInsert the 2 “AAA” batteries, making sure to set them inwith the proper polarity.1.Press and open the cover.2.Align the batteries according to the (+) and (–) indicationinside the case.3.Replace the cover.* The 1/8 Stereo Mini cable must be purchased separately.Operating Range* Use the remote control within a distance of about 7 m/23ft. from the front of the monitor’s remote control sensorand at horizontal and vertical angles of up to approximately30°.* The remote control operation may not function if themonitor’s remote control sensor is exposed to directsunlight or strong artificial light, or if there is an obstaclebetween the sensor and the remote control.Handling the remote control• Do not drop or mishandle the remote control.• Do not get the remote control wet. If the remote controlgets wet, wipe it dry immediately.• Avoid heat and humidity.• When not using the remote control for a long period,remove the batteries.• Do not use new and old batteries together, or use differenttypes together.• Do not take apart the batteries, heat them, or throw theminto a fire.• When using the remote control in the wireless condition,be sure to unplug the remote cable from the REMOTEIN terminal on the monitor.• When disposing of used batteries, please comply withgovernmental regulations or environmental publicinstruction’s rules that apply in your country/area.Using the wired remote control modeConnect the remote cable* to the remote control’s remotejack and the “REMOTE IN” terminal on the monitor.When the cable is connected, the mode automaticallyswitches to wired remote control. When the wired remotecontrol mode is used, the remote control can be operatedeven if no batteries are loaded.
