OneStart

Menu
Pioneer PHR100-55 Instruction Manual Manual pdf 4 page image

Pioneer PHR100-55 Instruction Manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 previewPage 22 previewPage 23 previewPage 24 previewPage 25 previewPage 26 previewPage 27 previewPage 28 previewPage 29 previewPage 30 previewPage 31 previewPage 32 previewPage 33 previewPage 34 previewPage 35 previewPage 36 previewPage 37 previewPage 38 previewPage 39 previewPage 40 previewPage 41 previewPage 42 previewPage 43 previewPage 44 previewPage 45 previewPage 46 previewPage 47 previewPage 48 previewPage 49 previewPage 50 previewPage 51 previewPage 52 previewPage 53 previewPage 54 previewPage 55 previewPage 56 previewPage 57 previewPage 58 previewPage 59 previewPage 60 previewPage 61 previewPage 62 previewPage 63 previewPage 64 previewPage 65 preview
Contents
  1. for the installer
  2. Table Of Contents
  3. Table Of Contents
  4. Table Of Contents
  5. B. IMPROPER COMBUSTION
  6. F. WINTERIZING
  7. C. OPTIONAL EQUIPMENT
  8. PART 3 – DIMENSIONS AND CLEARANCES
  9. PART 4 – PREPARE HEATER LOCATION
  10. B. LEVELING
  11. DIRECT VENT INSTALLATION OF EXHAUST AND INTAKE
  12. F. PREVENT COMBUSTION AIR CONTAMINATION
  13. PART 5 – PREPARE THE HEATER
  14. PART 6 – HEATER PIPING
  15. C. BACKFLOW PREVENTER
  16. F. INDIRECT FIRED WATER HEATER SCALDING
  17. H. FILL AND PURGE HEATING SYSTEM
  18. I. ZONING WITH ZONE VALVES
  19. L. PIPING DETAIL
  20. PART 7 – VENTING, COMBUSTION AIR AND CONDENSATE REMOVAL
  21. C. EXHAUST AND INTAKE AIR VENT PIPE LOCATION
  22. D. EXHAUST AND INTAKE AIR VENT SIZING
  23. E. LONGER VENT RUNS
  24. F. EXHAUST VENT AND INTAKE AIR PIPE INSTALLATION
  25. G. VENTING DRAWINGS
  26. INDOOR COMBUSTION AIR INSTALLATION IN CONFINED OR UNCONFINED SPACE
  27. H. EXHAUST VENT AND INTAKE AIR PIPE INSTALLATION
  28. J. CONDENSATE REMOVAL SYSTEM
  29. PART 8 – FIELD WIRING
  30. C. LINE VOLTAGE WIRING FOR STANDARD HEATER
  31. E. OUTDOOR SENSOR (OPTIONAL)
  32. H. UL353 LOW WATER CUT-OFF INTERFACE KIT (OPTIONAL
  33. J. CASCADE MASTER PUMP AND SENSOR WIRING
  34. K. CASCADE FOLLOWER PUMP AND SENSOR WIRING
  35. A. CHECK/CONTROL WATER CHEMISTRY
  36. C. FILL AND TEST WATER SYSTEM
  37. F. FINAL CHECKS BEFORE STARTING HEATER
  38. B. CASCADE SYSTEM
  39. D. STATUS MENU
  40. E. TEST MODE
  41. F. PURGE AIR FROM WATER SYSTEM
  42. PART 12 – TROUBLESHOOTING
  43. PART 13: MAINTENANCE
  44. MAINTENANCE NOTES
  45. HTP CUSTOMER INSTALLATION RECORD FORM
Pioneer PHR100-55 Instruction Manual Manual pdf 4 page image
4FOR THE INSTALLERThis appliance must be installed by qualified and licensed personnel. The installer should be guided bythe instructions furnished with the heater, and with local codes and utility company requirements. In theabsence of local codes, preference should be given to the National Fuel Gas Code, ANSI Z223.1-2002.INSTALLATIONS MUST COMPLY WITH:Local, state, provincial, and national codes, laws, regulations and ordinances.The latest version of the National Fuel Gas Code, ANSI Z223.1, from American Gas AssociationLaboratories, 8501 East Pleasant Valley Road, Cleveland, OH 44131.In Canada – CGA No. B149 (latest version), from Canadian Gas Association Laboratories, 55 ScarsdaleRoad, Don Mills, Ontario, Canada M3B 2R3. Also, Canadian Electrical Code C 22.1, from CanadianStandards Association, 5060 Spectrum Way, Suite 100, Mississauga, Ontario, Canada L4W 5N6.Code for the installation of Heat Producing Appliances (latest version), from American InsuranceAssociation, 85 John Street, New York, NY 11038.The latest version of the National Electrical Code, NFPA No. 70.This product is for installation in closed loop systems ONLY! Use of this product in any manner otherthan described in this manual may result in premature product failure, substantial property damage,severe personal injury, or death. Damage or failure of this product (or the system in which it is installed)due to unauthorized use IS NOT COVERED BY WARRANTY.This manual must only be used by a qualified heating installer/service technician. Read all instructions inthis manual before installing. Perform steps in the order given. Failure to comply could result in severepersonal injury, death or substantial property damage.
/ 65
This manual is suitable for:
PHR100-55PHR130-55PHR160-55PHR199-55
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved