Pioneer PDP-503CMX Service Manual

Also see for PDP 503CMX: Technical manual Quick reference parts lists Operating instructions Technical manual Technical manual

92PDP-503CMX, PDP-503MXE, PDA-5002I N I TPN OY E SU L S ME E T RE S E T ?– –S 1 I N 4 – 0 2 – ∗2 N T# 11151015165 10 15 20 25 30 35 40I N I TE E P D A T A R E A D 08-FF01:– –S 1 I N 4 – 0 2 – ∗2 N T# 11151015165 10 15 20 25 30 35 408. FINAL SET UP: Setting to the factory shipping state.(Refer to the Final Setup Details.)9. VIDEO STANDARD: Set the peak occurrences of STANDARD (USER MENU / POWER CONTROL) in the video system signal.(Set the following table 1.) Note: Please do not perform the change of setting in the service.10. PC STANDARD: Set the peak occurrences of STANDARD (USER MENU / POWER CONTROL) in the PC system signal.(Set the following table 2.) Note: Please do not perform the change of setting in the service.11. VIDEO MODE1: Set the peak occurrences of MODE1 (USER MENU / POWER CONTROL) in the video system signal.(Set the following table 3.) Note: Please do not perform the change of setting in the service.12. PC MODE1: Set the peak occurrences of MODE1 (USER MENU / POWER CONTROL) in the PC system signal.(Set the following table 4.) Note: Please do not perform the change of setting in the service.13. EEP DATA READ: Display the each address data of EEPROM.14. MASK1: Select the full mask. (Refer to "1 MASK1" .)Note: Mask 1/2 are commonness and perform one item last memory.15. MASK2: Select the mask pattern. (Refer to "2 MASK2" .)Note: Mask 1/2 are commonness and perform one item last memory.Caution: (item 14, 15 commonness)• When key operation is done and performs OSD display, turns OFF FULL MASK for two seconds and display OSD. (common to in all modes)• In FULL MASK selection (in MASK selection menu), Select the mask and turn off OSD two seconds later of no operation, and MASK screendisplays.• Perform MASK determination (press "SET"), and FULL MASK screen display starts.• Release of the mask is possible only with "M00" with the RS-232C factory adjustment mode or "MASK OFF" of the service factory menu.(Release is impossible with "FULL MASK OFF" of the integrator menu and "FMN" of the RS-232C command.)VIDEOCurrent Input SignalPL6 (fixed)PCTable1 Table2Table3STANDARD modeMODE1MODE2POWER CONTROLsetting Table4: YES/NO selectionSET : Store the SET DATA at YES selectionand shift to INIT screen.Hold the NOW DATA at NO selectionand shift to INIT screen.: Select the address (four places) place.5∞ : Select numeric value.SET : Shift to upper layer.Update display data (hex) every address modification.Display color : White (Selected address is yellow)Half tone : Blue (second row / 15th row foreach 5 to 36th columns)