Pioneer PD-10AE Instruction Manual

En- 4Precautions-ContinuedThe label on the right isapplied on the rear panel.1. This unit is a CLASS 1LASER PRODUCT andemploys a laser inside the cabinet.2. To prevent the laser from being exposed, do not removethe cover. Refer servicing to qualified personnel.For U.S. modelsFCC Information for UserCAUTION:The user changes or modifications not expresslyapproved by the party responsible for compliancecould void the user’s authority to operate theequipment.NOTE:This equipment has been tested and found to com-ply with the limits for a Class B digital device, pur-suant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference in a residential installation.This equipment generates, uses and can radiateradio frequency energy and, if not installed andused in accordance with the instructions, maycause harmful interference to radio communica-tions. However, there is no guarantee that interfer-ence will not occur in a particular installation. If thisequipment does cause harmful interference toradio or television reception, which can be deter-mined by turning the equipment off and on, theuser is encouraged to try to correct the interfer-ence by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipmentand receiver.• Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is con-nected.• Consult the dealer or an experienced radio/TVtechnician for help.For Canadian ModelsNOTE: CAN ICES-3 B/NMB-3 BFor models having a power cord with a polarizedplug:CAUTION: TO PREVENT ELECTRIC SHOCK,MATCH WIDE BLADE OF PLUG TO WIDE SLOT,FULLY INSERT.Modèle pour les CanadienREMARQUE: CAN ICES-3 B/NMB-3 BSur les modèles dont la fiche est polarisée:ATTENTION: POUR ÉVITER LES CHOCSÉLECTRIQUES, INTRODUIRE LA LAME LAPLUS LARGE DE LA FICHE DANS LA BORNECORRESPONDANTE DE LA PRISE ETPOUSSER JUSQU’AU FOND.For British modelsReplacement and mounting of an AC plug on thepower supply cord of this unit should be performedonly by qualified service personnel.IMPORTANTThe wires in the mains lead are coloured in accor-dance with the following code:Blue: NeutralBrown: LiveAs the colours of the wires in the mains lead of thisapparatus may not correspond with the colouredmarkings identifying the terminals in your plug,proceed as follows:The wire which is coloured blue must be con-nected to the terminal which is marked with the let-ter N or coloured black.The wire which is coloured brown must be con-nected to the terminal which is marked with the let-ter L or coloured red.IMPORTANTThe plug is fitted with an appropriate fuse. If thefuse needs to be replaced, the replacement fusemust approved by ASTA or BSI to BS1362 andhave the same ampere rating as that indicated onthe plug. Check for the ASTA mark or the BSI markon the body of the fuse.If the power cord’s plug is not suitable for yoursocket outlets, cut it off and fit a suitable plug. Fit asuitable fuse in the plug.For European ModelsWe declare, under our sole responsibility, that thisproduct complies with the standards:– Safety– Limits and methods of measurement of radiodisturbance characteristics– Limits for harmonic current emissions– Limitation of voltage changes, voltage fluctua-tions and flicker– RoHS Directive, 2011/65/EUWEEEhttp://www.onkyo.com/manual/weee/weee.pdfManufacturer:Onkyo & PioneerCorporation2-3-12 Yaesu, Chuo-ku,Tokyo104-0028 JAPANEU Representative’s:Pioneer Europe NVHaven 1087,Keetberglaan 1, 9120Melsele, Belgiumhttp://www.pioneer.eu