PIONEER CORPORATION1-1, Shin-ogura, Saiwai-ku, Kawasaki-shi, Kanagawa 212-0031, JAPANPIONEER ELECTRONICS (USA) INC.P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.TEL: (800) 421-1404PIONEER EUROPE NVHaven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/BelgiqueTEL: (0) 3/570.05.11PIONEER ELECTRONICS ASIACENTRE PTE. LTD.253 Alexandra Road, #04-01, Singapore 159936TEL: 65-6472-7555PIONEER ELECTRONICS AUSTRALIA PTY. LTD.5 Arco Lane, Heatherton, Victoria, 3202 AustraliaTEL: (03) 9586-6300PIONEER ELECTRONICS OF CANADA, INC.340 Ferrier Street, Unit 2, Markham, Ontario L3R 2Z5, CanadaTEL: 1-877-283-5901TEL: 905-479-4411PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.Blvd. Manuel Avila Camacho 138 10 pisoCol. Lomas de Chapultepec, Mexico, D.F. 11000TEL: 55-9178-4270© 2011 PIONEER CORPORATION.All rights reserved.© 2011 PIONEER CORPORATION.Tous droits de reproduction et de traductionréservés.Printed in JapanImprimé au Japon-A> EL <11F00000>UNIVERSAL REAR-VIEW CAMERACAMERA DE RECUL UNIVERSELLEOwner’s ManualMode d’emploiND-BC5① Glass surface② Make sure it doesn’t touch the wiper③ Install on the center partFig. 1Abb. 1𝖠 Rear view camera × 1 𝖢 Power supply unit × 1𝖡 RCA power supply cable × 1𝖣 Hexagon wrench × 1 𝖤 Hook and loop fastener(soft type) × 1𝖥 Hook and loop fastener(hard type) × 1𝖧 Waterproofpad × 1𝖦 Clamp × 6 𝖨 Double-sidedtape × 1Fig. 4Abb. 4Fig. 8Abb. 8Fig. 6Abb. 6Fig. 9Abb. 9② Bumper or rear edge of car① Power supply unit② Hook and loopfastener(hard type)③ Hook and loopfastener(soft type)① CamerastandFig. 2Abb. 2Fig. 3Abb. 3This device complies with part 15 of the FCCRules.Operation is subject to the following twoconditions:(1) This device may not cause harmful interference,and (2) this device must accept any interferencereceived, including interference that may causeundesired operation.Information to UserAlteration or modifications carried out withoutappropriate authorization may invalidate the user’sright to operate the equipment.Note:This equipment has been tested and found to complywith the limits for a Class B digital device, pursuantto Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference in a residential installation.This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications. However, thereis no guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipmentoff and on, the user is encouraged to try to correctthe interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment andreceiver.• Connect the equipment into an outlet on a circuitdifferent from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TVtechnician for help.If you want to dispose this product, do notmix it with general household waste. Thereis a separate collection system for used elec-tronic products in accordance with legisla-tion that requires proper treatment, recoveryand recycling.Private households in the 25 member states of theEU, in Switzerland and Norway may return theirused electronic products free of charge to designatedcollection facilities or to a retailer (if you purchase asimilar new one).For countries not mentioned above, please contactyour local authorities for the correct method of dis-posal.By doing so you will ensure that your disposed prod-uct undergoes the necessary treatment, recovery andrecycling and thus prevent potential negative effectson the environment and human health.WARNING:Handling the cord on this product or cords associatedwith accessories sold with the product may exposeyou to chemicals listed on proposition 65 known tothe State of California and other governmental enti-ties to cause cancer and birth defects or other repro-ductive harm. Wash hands after handling.IMPORTANTSAFEGUARDS• Installation and wiring of this product require spe-cialist skill and experience. To assure your safety,please request a specialist technician to install theunit.• Do not attempt to heat the surface of the cameralens or camera lens itself with a lighter and so onwhen they have become frozen. This can cause amalfunction.• This product is a rear view camera for checkingthe view at the rear of a car.A rear view camera is a camera that provides sym-metrical images in the same way as rear and sideview mirrors.• Connection to a TV with an RCA video input ispossible, but confirm whether the TV you use hasa reverse gear connection function.• This product is designed to supplement the driver’srear view, but the camera images do not show alldangers and obstacles. Be sure to look behind youwhen reversing to confirm the view.• This product features a wide-angle lens, so thenear view is wide and the far view is narrow,which may create a false sense of distance. Besure to look behind you when reversing to confirmthe view.• Do not wash your car with an automatic car washor high-pressure water as it may result in waterentering the camera or the camera falling off.• Check camera stand installation before driving.Are the screws loose?– Is the camera stand firmly secured?– If the rear view camera comes loose while youare driving it may cause an accident.⑥ Be sure not to hide any part of the char-acters on the license plate when attachingthe camera.Fig.5Abb. 5Fig. 7Abb. 7② Top③ Mark④ Bottom⑤ Make sure to install the rear view camera sothat the mark is located on top of the camera.① Hexagon wrench
