DVR-231-S 515 6 7 85 6 7 8CDFABE7.1.3 CPRM ID NUMBER AND DATA SETTINGFor the DVD recorder,it is necessary with the recoding/playback of DVD–RW disc to set an individual number(ID number) and ID data to each recorder. If the number and data are not set correctly with the followingprocedure, the unit will not be CPRM compatible, and CPRM recordings and playback can not be made onCPRM compatible DVD-RW discs. You will find the ID number to be set on the ID label on the rear panel.Important: If no ID label is found on the rear panel, write down the specified ID number by checking itaccording to "How to confirm the ID number" shown below.The Input is Necessary When:• " CPRM " flashing is displayed on the FL display immediately after the power is turned on or in Stop mode."Incorrect CPRM Information" is displayed on the OSD.• When the MAIN ASSY or DRIVE ASSY is replaced.Important: If no ID label is found on the rear panel, write down the specified ID number by checking itaccording to "How to confirm the ID number" shown below.• Input the ID number while the unit is in Stop mode.• Uses only the remote control for servicing except open/close key on the player.• After the data are read from the ID data disc (GGV1328), the disc will automatically be unloaded.[Purposes][Tools to be used][Notes]Remote control unit for servicing(GGF1381)DVD Recorder Data Disc(GGV1328) * GGV1328 will be available on June 2005.www . xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299http://www.xiaoyu163.comhttp://www.xiaoyu163.com